ABSORBENT SHOES

Canvas, Suede, Untreated Leather, Nubuck or Rough Leather, Cotton, etc.
1. Make sure shoes are dry and clean from greases or oils or any other dirt.
2. Spray 4-6 inches away.
3. Apply an even coat saturating shoes, but not to the point of dripping.
4. For best results, apply a second light coat 30-45 minutes after first coat is applied.
5. Let dry for 24 hours to properly cure onto the fabric for full protection.

NOTE: Depending on the amount you wear them you should reapply every 6 months to 1 year for maximum protection.

NON-ABSORBENT SHOES

Treated/Smooth Leather, Patten Leather etc.
1. Make sure shoes are dry and clean from greases or oils or any other dirt.
2. Spray 4-6 inches away.
3. Apply an even coat saturating shoes, but not to the point of dripping.
4. Allow to dry and absorb as much as possible for 1-2 minutes.
5. Wipe excess into shoes with a microfiber cloth.
6. For best results, apply a second light coat 30-45 minutes after first coat is applied.
7. Repeat steps 4-5
8. Let fully dry for 24 hours to properly cure onto the shoes for full protection.

NOTE: Depending on the amount you use them you should reapply every 6 months to 1 year for best protection.

 

 

Shoes!